Halo Max Bravo Drive Shower 

INSTRUCTIONS FOR INSTALLING A HALO MAX® ON A BRAVO

• 1. Remove black plastic caps, nuts and washers from each lift ram assembly.
• 2. Spread legs of Shower, align holes in the brackets over the lift ram shaft. Replace nuts and caps.
• 3. Lean Drive Shower forward and remove bolt and washer from bearing cap.
• 4. Place spacer (provided) over that hole.
• 5. Insert bolt (provided) through the top mounting tab, through the spacer and screw the bolt into the bearing cap until snug.
• 6. Install nuts onto lift ram assemble. DO NOT re-install washers. Tighten nuts and bolt to 30 ft. / lbs.

Additional step for installing a Halo© on a drive with Latham or Imco steering that attaches to the “Back Inspection Cap” To remove the top left stud from the drive, use a 3/8”-24 nut as a jam nut. Tighten the two nuts together so that you can place a socket over the jam nut and onto the original nut. Loosen both nuts at the same time.