|
|
|
|
602-WM100N Fits Good Automatic Windlass Rplc. Prestolite #'s EVH4001 & ESP4001 Good Part #21 3-Wire Connection Arco# 6213
|
|
602-9B-122B This kit works for Bravo One, Two and Three.
Alpha image shown, but it will include the proper Bravo long trim cylinder anodes.
|
|
602-89-101-01 Compatible with Kerr's Marine Tool 601 Floor Stand.
Swivels 360 Degrees
Adjustable working height from 32" to 51 1/2"
|
|
602-89-101-01K Compatible with Kerr's Marine tool 601 Floor Stand and TR400-1 Holder
Works with most 50 HP and up lower units and sterndrives.
Heavy duty steel construction with aluminum fork.
Swivels 360 degrees.
Adjustable working height form 32" to 51 1/2"
|
|
|
|
|
|
602-HL18HD HL18HD consists of a Hydraulic Pump Mounted on a Cylinder and totally Self Contained Cylinder Tube is Aircraft Quality 6063T832 Hard Coat Anodized Aluminum. The Rod is 5/8" Stainless Steel with an Aluminum Clevis Cylinder Length is 26" on centers Retracted with an 18"Stroke The Extended Length is 44" The 12 Volt DC Motor is SAE J1171Marine 2-Wire Permanent Magnet type The Maximum Hatch weight is 500 Pounds For larger boats with Heavier Hatches up to 1000 Pounds we recommend using 2 Cylinders and 1 Heavy Duty Hydraulic Pump.
|
|
602-HL24HD 1" Bore Cylinder 32.00" On Centers Retracted Length With An 24.00" Stroke And A 56.00" Extended Length Motor Is SAE J1171 Marine
|
|
|
|
|
|
|
|
602-RS100 Marine Rocker 12 Volts Dc. Momentary On-Off-On, Six Pole.
|
|
|
|
|
|
602-90-121-02 This item is to replace 1992 and up Bravo One's with the oil passage.
It can be modified to backfit 1988-1991.
The oil passage in the waterway has to be plugged on early models that do
not have the passage in the upper. It is best to drill and tap the hole and
install a set screw with sealant. Make sure to place the screw flush or
slightly below the surface.
This unit has side water intakes only. For dual water intakes see SE122.
|
|
602-90-122-02 This item is to replace 1992 and up Bravo One's with the oil passage.
It can be modified to backfit 1988-1991.
The oil passage in the waterway has to be plugged on early models that do
not have the passage in the upper. It is best to drill and tap the hole and
install a set screw with sealant. Make sure to place the screw flush or
slightly below the surface.
This unit has side and low water intakes. For side water intakes only see SE121.
|
|
602-90-205-03K SE205 Install Kit includes:
Qty 5 Mounting Nut 98-205-12
Qty 5 Washer, mounting nut 98-205-83
|
|