602-93-102-13 Fits Mercruiser MR, Alpha I & Alpha Gen II
OE# 31-36387A 1
Driveshaft Bearing
Units with driveshaft retaining nut
Not for use in units with a preload pin driveshaft
|
|
602-92-102-02 Fits Mercruiser I, R, MR, Alpha I
1973-1990
not for GEN II drives
|
|
602-92-216-04-20 Fits Mercury / Mariner 3.0 liter V6
0G960500 & up
20" model only
Uses two upper driveshaft bearings
|
|
602-92-216-04-25 Fits Mercury / Mariner 3.0 liter V6
0G960500 & up
25" model only
Uses two upper driveshaft bearings
|
|
602-92-216-04-30 Fits Mercury / Mariner 3.0 liter V6
0G960500 & up
30" model only
Uses two upper driveshaft bearings
|
|
602-93-102-13A Fits Mercruiser I, R sterndrives
Driveshaft bearing
OE # 31-53079A-1
For use on models with pre-load pin driveshafts
Fits Mercury / Mariner
V6 (2.0 and 2.4 liter) early models
With pre-load pin driveshaft
|
|
602-92-116-04G Fits Mercruiser GEN II drives 0K999999 and below
OE# 45-816919
Driveshaft for SE116
Also used on early 3.0 Mercury outboards with two piece driveshafts
|
|
|
|
|
602-89-101-23 Converts splined driveshaft to a hex head to aid in removing and installinf the driveshaft on Alpha one and Gen II lowers.
Also works on 13 Spline Mercury 3.0L lower units.
|
|
|
|
|
602-92-205-04-20A Fits Mercury / Mariner metric 3 & 4 cylinder
70-125 hp
20" Two stroke
Carb
13 Spline
|
|
602-92-205-04-25A Fits Mercury / Mariner metric 3 & 4 cylinder
70-125hp
25" Two stroke
Carb
|
|
602-92-205-04-20B Fits Mercury / Mariner 3 & 4 cylinder
75-115hp
DFI (Optimax)
20" 13 spline
|
|
602-92-205-04-25B Fits Mercury / Mariner 3 & 4 cylinder
75-115hp
DFI (Optimax)
25"
|
|
602-92-205-04-20E Fits Mercury / Mariner 30-50hp four stroke
Carburated
20" Bigfoot lower only
13 Spline
|
|
602-92-205-04-20G Fits Mercury / Mariner 40-60 hp 4 stroke
20" Bigfoot lower only
17 Spline
|
|
602-92-205-04-20C Fits Mercury / Mariner 4 stroke EFI
70-115hp 20"
1B366822 and below
18 Spline
|
|
602-92-205-04-25C Fits Mercury / Mariner 4 stroke EFI
70-115hp 25"
1B366822 and below
|
|
|
|
|
|
|
|
