IMCO Marine

Vertical Shaft SCX,SCXT (Lower)

Vertical Shaft Spacer

2 Required per drive

Vertical Shaft-1" Shorter

Vertical Shaft-Standard Length

Washer (1" Spring, #6 Shaft)

Washer (1/2" AN S/S)

4 per Gimbal Steering and Trim Assembly

Washer (3/4" Spring)

Washer (3/8" AN) Stainless Steel

2 per Upper Case Assembly

Washer (3/8" Star)

2 per Upper Case Assembly

Washer (7/16" AN S/S Thin)

8 per Upper Case Assembly, 2 per Lower Case Assembly

Washer (Small Hole-Trim Pin S/S)

2 per Gimbal Ring Assembly

Washer (Yoke Gear End)

Wear Pad Kit (Right & Left)

2 per Upper Case Assembly

Weld on Shift, ECM, or EFI module brackets

(Should be ordered with riser pipes) Brackets are welded directly to PowerFlow stainless steel risers as pictured for a clean look. Shift bracket or ECM unit mounts directly to bracket. (PLEASE MAKE NOTE OF EIGHTER SHIFT BRACKET OR ECM BRACKET OR BOTH (2)  BRACKETS  AS NEEDED)

Picture shown with bracket welded on a Big Block "A" Riser

Wing Plate Kit Mercury 200 225 250 300 XS Polished 304 SS. Includes parts shown only, fits single engine.