Generic

Nipple Brass 1/8 X 3 1/2 NOT TO BE USED IN POTABLE WATER SYSTEMS.

Size: 1/8" dia.", Length: 3-1/2"

Insulates and protects connections from mechanical abuse, wire pullout and abrasion. Heat activated adhesive lining provides impervious seal to salt water, oil, acids, and sunlight as well as providing strain relief. Highest shrink ratio - shrinks to 1/3 original size. Shrinks at 257° F/125° C.

Size: 1/8" x 3", Color: Black, Pack: 3

Sold: Pack

1/8 X 3 Brass Pipe Nipple NOT TO BE USED IN POTABLE WATER SYSTEMS.

Size: 1/8" dia.", Length: 3"

1/8 X 4 Brass Pipe Nipple NOT TO BE USED IN POTABLE WATER SYSTEMS.

Size: 1/8" dia.", Length: 4"

1/8 X Close Brass Pipe Nipple NOT TO BE USED IN POTABLE WATER SYSTEMS.

Size: 1/8" dia.", Length: Close (3/4)

-10 AN 120° Fixed Hose End

• Available: (7) Seven
• Condition: Overstock

-10 AN 180° Fixed Hose End

• Available: (12) Twelve
• Condition: Overstock

-10 AN 30° Fixed Hose End

• Available: (13) Thirteen
• Condition: Overstock

-10 AN to 5/8" Push-On Hose End

• Available: (1) One
• Condition: Overstock

Ethernet Cable, AS EC 10E

Description: 10', Model: AS EC 10 E

Use as common hot feed or common ground block. Heavy plastic base with solid brass terminal bar and screws. Two stud terminals for main power connection.

Gang: 10, Terminal Screw: 8-32 Screw, Size: 5.75'' x 1.25''

Stamped brass, molded bakelite.

Gang: 10, A: 5-3/4", B: 1-1/4", C: 1-1/16", D: 5-3/16"

Sold: Each

10 Gang Screw Type Bus Bar, 150 Amp

Gang: 10, Terminal Screw: 8-32 Screw, Amps: 150, Size: 6'' x 1.25''

Size: 2" x 10', Break Strength: 1200 lbs.

• 2" Nylon webbing
• Heavy gauge zinc-plated hardware
• Captive "J" hook
• Self tightening, easy-lock over centering buckle
• Velcro pad to protect surfaces

"Durable orange polyurethane. Will not mark or discolor boat. Cut and abrasion resistant. Will not "flat spot" even after months of storage. Roller is unaffected by grease, oil, gasoline, exhaust fumes, salt, etc. No bushings to pop out. Continuous bearings and reinforcing tubes on rollers over 7" long are completely enclosed in polyurethane. Shafts should be greased at installation."

Size: 10", Hole: 5/8", Reinforcing Tube: Yes, Case: 16

Sold: Each

Spin-On series filters these filters are designed for high performance applications, and with flow rates between 30 and 120 GPH your engine will perform better than ever with clean, waterfree fuel. These filters are coated with a durable electrostatically applied powder coating for superior corrosion resistance. Features a high capacity Aquabloc^® II 10 micron filter element that removes sediment from water up to 99%. This Spin-On filter design is simple to replace and the re-usable clear plastic or metal contaminant collection bowls feature a self-venting drain, or metal plug, for removing unwanted muck and water. Max pressure 7 psi.
Clear Bowls: Use for outboard and above deck installations.
Metal Bowls: USCG regulations require the use of flame resistant metal bowls below deck.

GPH: 30, Micron: 10, Ports: 1/4"-18 NPTF", Bowl: Metal, Application: Inboard/Outboard, Size: 3.2" D x 3.2" W x 6" H"

Sold: Each

10 Quart 396-454 Gen 4 Big Block Chevy V-drive Oil Pan

• Length: 20.75"
• Width: 8.2"
• Height: 7.8"
• Fits: Gen 4 big block Chevy engine
• 1/2"-20 drain plug
• Includes pickup

Dooley Marine is recognized worldwide for building one of the largest selections of V-drive oil pans today.

10 Quart 429-460 Ford V-drive Oil Pan

All 429 -460 Ford oil pan units come with the pan, pickup, windage tray and a packet of main cap bolts to mount the pick-up and tray. All pans also keep the pick-up to the rear of the vehicle for positive oil pressure on acceleration. Pickups are available for push-in bolt-on from the rear of the pump (van or truck pump), or bolt-on from the bottom of the pump at an angle (Cobra Jet pump). Please specify pump type when ordering. 460 Ford jet boat pans taper to the rear for jet pump clearance. If you are not sure which pump you have, give us a call & we will help you figure it out.

• 1/2"-20 drain plug

Dooley Marine is recognized worldwide for building one of the largest selections of V-drive oil pans today.

"Can be used with all SeaStar systems except BayStar, Capilano and 3-line inboard systems. Includes 2 hoses. ID of 5/16". Not for use with SeaStar Pro systems."

Length: 10', Box: 2

Sold: Box

Extremely effective in reducing engine exhaust noise and preventing water from returning to the engine. High strength design provides a significant safety margin over other existing fiberglass lift mufflers. Exceeds ABYC specifications. For Gas/Diesel fuel type Inboards, Sailboats & Generator applications. Sound rating: Better. Use above or below the waterline.

A1: 2, A2: 2, B: 2.5, D: 10.04, F: 2.5, H: 10.16

Sold: Each