Your shopping cart is currently empty.
200XS DFI 2.5L ROS - Serial 1E050852 and Up - Air Compressor Components, SN 1B884881 and up
Other Sub-Sections:
- Air Compressor Components, SN 1B884880 and below
- Air Compressor Components, SN 1B884881 and up
- Air Handler Components
- Air Handler/Flywheel Cover
- Air Hoses
- Bottom Cowl
- Coil Plate Assembly
- Crankshaft, Pistons and Connecting Rods
- Cylinder Block and End Caps
- Cylinder Head
- Driveshaft Housing
- Electrical Plate Assembly
- Exhaust Plate
- Flywheel/Alternator
- Fuel Hoses
- Fuel Pump
- Fuel Rails
- Gasket Set Components, Complete Powerhead and Lower Unit
- Gear Housing(Drive) Standard/Counter Rotatation-Sportmaster
- Gear Housing, Propeller Shaft-Counter-Sportmaster
- Gear Housing, Propeller Shaft-Standard-Sportmaster
- Oil Injection Components
- Oil Lines
- PCM Mounting
- Starter Motor
- Swivel Bracket(Short)
- Throttle Lever And Shift Shaft
- Top Cowl
- Transom Brackets(Short)
- Trim Pump and Mounting Brackets
- Vapor Separator Components
- Water Hoses
Ref. | OEM Part # | Hardin # | Mallory # | GLM # | Other # | Description | Num Req. | Superceded From | Special Notes |
1 | 8M0060053 | COMPRESSOR ASSEMBLY, Air | 1 | ||||||
2 | NSS | Body | 1 | Not Sold Separate | |||||
3 | 1100-8M0060381 | END CAP ASSEMBLY | 1 | ||||||
4 | 10-8M0045380 | SCREW, (M8 x 50) | 1 | ||||||
5 | 25-67206001 | O-RING | 1 | ||||||
6 | 25-67206001 | O-RING | 1 | ||||||
7 | 10-85593920 | SCREW, (M6 x 20) | 4 | ||||||
8 | 653-833146T06 | CONNECTING ROD ASSEMBLY | 1 | ||||||
9 | NSS | Bearing | 1 | Not Sold Separate | |||||
10 | NSS | Bearing | 1 | Not Sold Separate | |||||
11 | NSS | Piston assembly (W/Rings and Pin) | 1 | Not Sold Separate | |||||
12 | NSS | Oil Scraper Ring | 1 | Not Sold Separate | |||||
13 | NSS | Top Ring | 1 | Not Sold Separate | |||||
14 | NSS | Oil Ring | 1 | Not Sold Separate | |||||
15 | NSS | Wrist Pin | 1 | Not Sold Separate | |||||
16 | NSS | Piston with Wrist Pin | 1 | Not Sold Separate | |||||
17 | 53-8348101 | RING, Lock, Lock | 2 | ||||||
18 | 835088A10 | REED PLATE ASSEMBLY | 1 | ||||||
19 | 25-67207 | O-RING, (3.489 x .070) | 2 | ||||||
20 | 25-832804 | O-RING, (2.739 x .070) | 1 | ||||||
21 | 26-828225 | SEAL | 1 | ||||||
22 | 8M0073890 | HEAD KIT, Compressor | 1 | ||||||
23 | 22-8307535 | FITTING, Straight | 1 | ||||||
23 | 22-8M0042974 | FITTING, (1.87 Inches) | 1 | ||||||
24 | 10-82127335 | SCREW, (M8 x 35 MM) | 4 | ||||||
25 | 13536A14 | SENSOR ASSEMBLY, Temperature | 1 | ||||||
26 | 137151 | RETAINER | 1 | ||||||
27 | 10-81893414 | SCREW, (M8 x 14) | 1 | ||||||
28 | 25-831985 | O-RING, (.468 x .078) | 1 | ||||||
29 | 22-151331 | FITTING | 1 | ||||||
30 | 21-428641 | FITTING, Check Valve | 2 | ||||||
31 | 22-856744 | FITTING | 1 | ||||||
32 | 22-14868 | FITTING | 1 | ||||||
33 | NSS | Decal-Assy. Instructions | 1 | Not Sold Separate | |||||
34 | 10-85593920 | SCREW, (M6 x 20) | 6 | ||||||
35 | 25-855349002 | GROMMET | 1 | ||||||
36 | 22-851975 | FITTING, Elbow - 45 Degree - Brass (.125-27) | 1 | ||||||
37 | 10-4010825 | SCREW, (M10 x 25) Hex Flange - Stainless Steel | 2 | ||||||
38 | 16-858762001 | STUD, (.312-18/.312-24 x 4.190) | 2 | ||||||
39 | 12-854640 | WASHER, Special | 4 | ||||||
40 | 11-46356 | NUT, (.312-24) | 2 | ||||||
41 | 8M0051194 | PULLEY, Compressor | 1 | ||||||
42 | 54-8M0024533 | CLAMP | 1 | ||||||
43 | 12-884594 | WASHER | 1 | ||||||
- | 25-832804A03 | O-RING KIT | 1 |