Your shopping cart is currently empty.
8.2L Mag (Base or HO) - Serial 1A351597 and Up - Cylinder Block And Camshaft
Other Sub-Sections:
- Alternator
- Cool Fuel System
- Cooling System, Fresh Water Components
- Cooling System, Raw Water Components, Port
- Cooling System, Raw Water Components, Starboard
- Crankshaft, Piston, Connecting Rods
- Cylinder Block And Camshaft
- Cylinder Head
- Drain Fitting Assembly
- Drive Lube Reservoir Assembly
- Electrical Components
- Engine Mounts
- Exhaust Manifold, Elbow And Riser
- Exhaust System Components
- Flywheel Housing
- Fuel Module Components -Bravo
- Gasket Set, Overhaul
- Intake Manifold
- Jackshaft Main Kit
- Oil Pan And Oil Pump
- Remote Oil System
- Seawater Pump
- Shift Bracket, Digital Throttle And Shift
- Shift Bracket, Mechanical
- Starter Motor
- Steering Components
- Throttle Body, Digital Throttle-Shift
- Throttle Body, Mechanical Throttle-Shift
- Throttle Lever Assembly, Mechanical Throttle-Shift
- Trim Pump And Motor Components
- Trim Pump Assembly
- Water Drain System
- Water Pump And Front Cover
- Wiring Harness And Lifting Brackets
Ref. | OEM Part # | Hardin # | Mallory # | GLM # | Other # | Description | Num Req. | Superceded From | Special Notes |
- | 8M0074038 | LONGBLOCK ASSEMBLY | 1 | 8M0045344 | |||||
1 | NSS | NOT SOLD SEPARATE, BLOCK | 1 | This Part is not sold separately (Order Longblock Assembly) | |||||
2 | 22-32561 | PLUG, Pipe - Allen Head (.250-18) | 6 | ||||||
3 | 17-843379 | PIN, Dowel (.6206/.6211 x 1.20), Flywheel Housing | 2 | 5 | |||||
4 | 22-328022 | PLUG, Pipe (.125-27) Brass | 1 | ||||||
5 | 16-862915 | STUD, (.250-18/M10 Special) | 2 | ||||||
6 | 8M0044048 | VALVE ASSEMBLY, Pressure Relief | 1 | ||||||
7 | 17-843378 | PIN, Dowel (.250) Bottom Of Block | 2 | 5 | |||||
8 | 22-36373 | PLUG, (.375-18) Hex - Steel | 1 | NOTE: Bottom Of Block Oil Plug 5 | |||||
8 | 22-36373 | PLUG, (.375-18) Hex - Steel | 2 | NOTE: Rear Of Block Oil Plugs 5 | |||||
9 | 22-64013 | FITTING, (.375 Male To .125 Female) | 1 | ||||||
10 | 881879T11 | SENSOR, Pressure (0 - 100 PSI) | 1 | ||||||
11 | 22-36382 | 700-21887 | FITTING, (.250-18 x .62) Brass, Lower Side Of Block | 2 | 5 | ||||
12 | 19-34270 | EXPANSION PLUG, (1.625) | 6 | 5 | |||||
13 | 11-826292 | NUT, (M10) Brass/Nickel Plated | 2 | MCM | |||||
14 | 22-29085 | FITTING, Elbow (45 Degree) | 1 | ||||||
15 | 17-843378 | PIN, Dowel (.250) Timing Cover | 2 | 5 | |||||
16 | 22-8M0044324 | PLUG, (1/4 Inch), Pipe | 2 | 5 | |||||
17 | 22-36373 | PLUG, (.375-18) Hex - Steel | 1 | 5 | |||||
18 | 10-16498 | SCREW, (.375-16 x .750) Button Head - Stainless Steel | 2 | 5 | |||||
19 | 8M0001406 | PLATE, Block Off - Fuel Pump | 1 | 5 | |||||
20 | 27-34213 | 676-9-61041 | 700-31360 | GASKET, Block Off Plate | 1 | 2,5 | |||
21 | 22-390721 | PLUG, Pipe (.125-27) Brass | 1 | 5 | |||||
22 | 22-479452 | PLUG, Oil Gallery | 3 | 5 | |||||
23 | 10-8M0044047 | SCREW, (.312-18 x .62), Lifter Guide Retainer to Block | 4 | 5 | |||||
24 | 8M0050807 | RETAINER, Lifter Guide | 1 | 5 | |||||
25 | 845756T | SHEILD, Oil Intake | 1 | 5 | |||||
26 | 8M0045287 | DRIVE, Oil Pump | 1 | 5 | |||||
27 | 10-8M0043925 | SCREW, (.312-18 x 1.0), Oil Pump Driver to Block | 1 | 5 | |||||
28 | 12-56720 | WASHER, (.330 x .750 x .060) Stainless Steel | 1 | 5 | |||||
29 | 19-94140 | EXPANSION PLUG | 1 | 5 | |||||
30 | 845754 | GUIDE, Lifter | 8 | 5 | |||||
31 | 849947T01 | LIFTER | 16 | 5 | |||||
32 | 8M0046343 | CAMSHAFT | 1 | 5 | |||||
33 | 23-85684 | BEARING SET | 1 | 5 | |||||
34 | 8M0043109 | PIN, Dowel | 1 | 5 | |||||
35 | 845941 | RETAINER, Gear Thrust | 1 | 2,5 | |||||
36 | 10-845943 | SCREW, (.250-20 x .500) | 2 | 5 | |||||
37 | 8M0045987 | CHAIN, Timing | 1 | 5 | |||||
38 | 43-843004 | SPROCKET, Crankshaft | 1 | 5 | |||||
39 | 43-899852T | SPROCKET, Camshaft | 1 | 5 | |||||
40 | 8M0050760 | WHEEL, Sensor Target | 1 | 5 | |||||
41 | 10-8M0043993 | SCREW, (.312-18 x.75), Camshaft Spocket to Camshaft | 3 | ||||||
42 | 878187 | SENSOR ASSEMBLY, Knock | 2 |